Broadcom NetXtreme Ethernet Adapter • Diagnostic User’s Guide
page 88
Broadcom Confidential and Proprietary
10.11 upgfrm
Command:
upgfrm
Description:
Upgrade ISCSI, PXE, Boot Code and Selfboot Firmware from a File. This
command reads code from a file and program into iscsi, pxe or boot area. Both parameter,
the programming target '-p', 'b' or '-i' and filename, must be specified. In case of ISCSI
firmware, ISCSI Boot Firmware will be updated by default. ISCSI CFG Block will only be
updated if there is no ISCSI CFG Block present in NVRAM. ISCSI CFG Program will
NOT be programmed by this command. In case of Selfboot Firmware, this command will
support Format 0 to Format 1 and Format1 to Format1 update. Format0 to Format0 and
Format1 to Format0 update are NOT supported by this command. User will need to use
“seprg” command. For legacy bootcode, only VPD data block and Phase 1 and Phase 2
bootcode will be updated by default. If –v is entered, only Phase 1 and Phase 2 bootcode
will be updated. For Selfboot firmware and Hardware Selfboot firmware, only patches will
be updated.
Syntax:
upgfrm <p | b | I| v> filename
upgfrm [-f<filename>] [-b | -p | -i] | [-d] | [-v]
Options:
-b
Upgrade boot code/Selfboot firmware
-d
Do not perform device check
-f<string>
Input file
-p
Upgrade PXE code
-i Upgrade ISCSI code
-r Do not perform chip rev. check for Selfboot
-n<HEX> Set PFN when loading LOM PXE code
-v Preserve VPD block data in legacy bootcode upgrade
10.12 sever
Command:
sever
Description:
Display Serial NVRAM Version
Syntax:
sever
