Broadcom NetXtreme Ethernet Adapter • Diagnostic User’s Guide
page 28
Broadcom Confidential and Proprietary
PART_NUMBER
= string (16)
ENGINEERING_CHANGE
= string (10)
MANUFACTURING_ID
= string (4)
ASSET_TAG
=
string
(16)
FORCE_PCI
=
{enable,
disable}
VOLTAGE_SOURCE
= {1.3, 1.8}
LED_MODE
=
{mac_mode,
triple_link /phy_mode1, link_speed/phy_mode2,
shared_traffic, shasta_mac,
wireless_combo}
MAX_PCI_RETRY
= {0..7, auto}
ASF
=
{enable,
disable}
DUAL_MAC_MODE
= {normal, mac0, mac1, xbar, swap, swapxbar} **
normal: Ch.0 and Ch. 1 enableds
macb: Ch.0 enabled, Ch.1 disabled
maca: Ch.0 disabled, Ch.1 enabled
xbar: Both MACs shares one function in PCI configuration space
swapxbar :
swap: swap between Ch.0 and Ch1.
MBA_BOOT_PROTOCOL
= { pxe, rpl, bootp, iscsi}
MBA_BOOTSTRAP_TYPE
= {auto, bbs, int18, int19}
MBA_DELAY_TIME
=
{0..15}
EXPANSION_ROM_SIZE
= {64K, 128K, 256K, 512K, 1M, 2M, 4M, 8M, 16M}
DESIGN_TYPE
=
{nic,
lom}
VENDOR_SPECIFIC0 = string (16)
VENDOR_SPECIFIC1 = string (16)
REVERSE_NWAY = {yes, no}
WOL_LIMIT_10
= {yes, no}
FIBER_WOL_CAPABLE = {yes, no}
CLOCK_RUN_SETTING
= {enable, disable}
DISABLE_POWER_SAVING
= {yes, no}
HIDE_MBA_SETUP_PROMPT = {enable, disable}
MBA_SETUP_HOT_KEY
= {Ctrl-S, Ctrl-B}
ENABLE_AUTO_POWERDOWN = {yes, no}
CAPACITIVE_COUPLING
= {enable, disable}
PRI_SMB_ADDR = {Hex(value)}
SEC_SMB_ADDR = {Hex(value)}
*This should only be used to select port for dual ports devices.
** This is for dual port devices only.
For Selfboot Firmware:
MAC_ADDRESS
= xx:xx:xx:xx:xx:xx
SYSTEM_DEVICE_ID
= xxxx
SUBSYSTEM_VENDOR_ID = xxxx
SUBSYSTEM_DEVICE_ID
= xxxx
WOL
= {enable, disable}
WOL_LIMIT_10
= {yes, no}
DESIGN_TYPE
=
{nic,
lom}
ENABLE_AUTO_POWERDOWN
= {yes, no}
REVERSE_NWAY
= {yes, no}
DISABLE_POWER_SAVING
= {yes,no}
CABLE_SENSE =
{enable,
disable}
LED_MODE
= {mac_mode, phy_mode1, phy_mode2,
shared_traffic, shasta_mac,
wireless_combo}
POWER_DISSIPATCHED _CONSUMED
= d0:d1:d2:d3:d4 *
PCIE_POWER_BUDGETING_DATA = x0:x1:x2:x3:x4 **
