Broadcom NetXtreme Ethernet Adapter • Diagnostic User’s Guide
page 140
Broadcom Confidential and Proprietary
/* ERR_CHIP_NOT_RUNNING 50 */ "Cannot perform task while chip is not running. (need
driver)",
/* ERR_NO_REG_DEF 51 */ "Cannot open register define file or content is bad",
/* ERR_ASF_RST 52 */ "ASF Reset bit did not self-cleared",
/* ERR_ASF_ATTN_LOC 53 */ "ATTN_LOC %d cannot be mapped to %cX CPU event bit %d",
/* ERR_ASF_RST_VAL 54 */ "%s Regsiter is not cleared to zero after reset",
/* ERR_ASF_PA_TIMER 55 */ "Cannot start poll_ASF Timer",
/* ERR_ASF_PA_CLEAR 56 */ "poll_ASF bit did not get reset after acknowleged",
/* ERR_ADF_NO_STAMP 57 */ "Timestamp Counter is not counding",
/* ERR_ADF_NO_TIMER 58 */ "%s Timer is not working",
/* ERR_ASF_EVENT 59 */ "Cannot clear bit %s in %cX CPU event register",
/* ERR_EEP_FILESIZE 60 */ "Invalid %s file size, expected %d but only can read %d
bytes",
/* ERR_MAGIC_VALUE 61 */ "Invalid magic value in %s, expected %08x but found
%08x",
/* ERR_EEP_FMT 62 */ "Invalid manufacture revision, expected %c but found
%c",
/* ERR_EEP_BOOTVER 63 */ "Invalid Boot Code revision, expected %d.%d but found
%d.%d",
/* ERR_EEP_CANNOT_WRITE 64 */ "Cannot write to NVRAM",
/* ERR_EEP_CANNOT_READ 65 */ "Cannot read from NVRAM",
/* ERR_BAD_CHECKSUM 66 */ "Invalid Checksum",
/* ERR_BAD_MAGIC_VALUE 67 */ "Invalid Magic Value",
/* ERR_MAC 68 */ "Invalid MAC address, expected %02X-%02X-%02X-%02X-%02X-
%02X",
/* ERR_BUS 69 */ "Slot error, expected an UUT to be found at location
%02X:%02X:00",
/* ERR_SPEC_MEM 70 */ "Adjacent memory has been corrupted while testing block
0x%08x-0x%08x\nGot 0x%08x @ address 0x%08x. Expected 0x%08x",
/* ERR_NOT_SUPPORT 71 */ "The function is not Supported in this chip",
/* ERR_BAD_CRC 72 */ "Packets received with CRC error",
/* ERR_MII_ERR_BITS_SET 73 */ "MII error bits set: %04x",
/* ERR_INIT_MAC 74 */ "CPU does not initialize MAC address register
correctly",
/* ERR_FW_FILE_FORMAT 75 */ "Invalid firmware file format",
/* ERR_RESET_TX_CPU 76 */ "Resetting TX CPU Failed",
/* ERR_RESET_RX_CPU 77 */ "Resetting RX CPU Failed",
/* ERR_INVALID_MAC_ADDR 78 */ "Invalid MAC address",
/* ERR_MAC_REG 79 */ "Mac address registers are not initialized correctly",
/* ERR_BOOTCHECKSUM 80 */ "NVRAM Bootstrap checksum error",
/* ERR_VPD_READONLY 81 */ "Write operation changed VPD read only data from %08X to
%08X at %04X",
/* ERR_VPD_READ 82 */ "Cannot read data from VPD address %04X",
/* ERR_MEM_READ 83 */ "Memory read and compare error",
/* ERR_MEM_WRITE 84 */ "Memory write error", /* no longer in use */
/* ERR_PXE_PGM 85 */ "PXE Programming Error",
/* ERR_PXE_VFY 86 */ "PXE Verification Error",
/* ERR_EXT_MEM_EXE_TIMOUT 87 */ "Cannot execute code from external memory, pc=%08X",
/* ERR_EXT_MEM_SIZE 88 */ "External memory size detection error",
/* ERR_RESET_TIMEOUT 89 */ "Reset Time",
/* ERR_MSI_ERR_NOTCLEAR 90 */ "MSI Error bits are not cleared after reset",
/* ERR_MSI_DATA 91 */ "MSI expected %04X, but read %04X at %08X",
/* ERR_MEM_INIT 92 */ "mem pool initialization failed",
/* ERR_MEM_UNINIT 93 */ "mem pool un-initialization failed",
/* ERR_PCI_REGS_WIDTH 94 */ "Read/Write PCI regs width %d affects wider than
expected at offset 0x%X",
/* ERR_LINK_STATUS 95 */ "Link status error in auto-polling mode",
/* ERR_PHY_INTERRUPT 96 */ "Phy interrupt did not happen",
/* ERR_EEP_BIT_BANG 97 */ "EEprom test fails in bit-bang mode at address %X",
/* ERR_ROM_SIZE 98 */ "ROM size error\nExpected %08X but read %08X at\nROM Bar
(0x30) register with %d written to ROM size reg.(0x88)",
/* ERR_ROM_DATA 99 */ "Data Error\nExpected %08X but read %08X at %08X",
/* ERR_ROM_ENABLE 100 */ "Expansion ROM Desired bit is not set after loading
firmware",
/* ERR_GPIO 101 */ "GPIO%d Error, write=%d, read=%d",
