53-1004105-13 Hardware Installation Guide
Brocade X6-8 Director
Hardware Installation Guide
6. Fasten the port side of the device to the rack rails. Use three 10-32 x 5/8 inch (1.58 cm) screws per rail. Tighten the
screws to a torque of 37 cm-kg. (32 in.-lb).
NOTE
Do not use the top or bottom holes of the mounting bracket because the screw heads will interfere with the
door.
Figure 7: Attaching Port Side of Device to Rack Rails
1. 10-32 x 5/8 in. (1.58 cm) Panhead Phillips Screw with Washer
7. Reinstall the device door if removed from your device.
Installing the 14U Chassis Mid-Mount Rack Kit for Two-Post Racks
(XBR-DCX-0121)
Use the following instructions to install a Brocade modular device in a telecommunications (Telco) rack, using the 14U
Chassis Mid-Mount Rack Kit for Two-Post Racks (XBR-DCX-0121).
Observe the following considerations when mounting this device:
•
The kit is compatible with rack rails that are either 7.6 cm (3 in.) or 12.7 cm (5 in.) wide (adapters are provided for 7.6
cm [3-in.] rails).
•
Before mounting your device, review any specific installation and facility requirements in this Hardware Installation
Guide.
•
Hardware devices illustrated in these procedures are only for reference and may not depict the device you are
installing into the rack.
53-1004105-13
32
Broadcom
Summary of Contents for Brocade X6-8 Director
Page 207: ......
