Document: SLSA-MIP-5-4-0-US
Date of Issue: 05/2016
Revision: -
11-7
Connect the strobe/position lights wire.
Set the strobe/position light to the wing tip and fasten it with bolts.
NOTE
Before installing the strobe/position light thoroughly clean the contacting surfaces on the light
and on the wing tip of the putty residues.
Install the covering glass of the strobe/position lights.
Seal the position light edges by polyurethane sealer to prevent water from in leaking
under the position light.
11.3.5
Removal of the optional landing light
Type of maintenance: line
Authorization to perform:
Sport pilot or LSA mechanic
Tools needed:
Wrench size 7/16 in
Unscrew the side screws from the landing light bracket.
Remove the bulb and disconnect the wires on the rear side of it.
11.3.6
Installation of the optional landing light
Type of maintenance: line
Authorization to perform:
Sport pilot or LSA mechanic
Tools needed:
screwdriver
Set the wires into the light connector from the rear side of the bulb.
Set the headlight into the case and screw on the attachment bracket.
Adjust the landing light (see 11.4.1).
Summary of Contents for S-LSA
Page 2: ......
