Centipede 2
®
Module System Instructions
BriskHeat
®
Corporation. All rights reserved
31
Insulation
Stranded Wire
6mm (1/4
”)
APPENDIX 3: ALARM RELAY INSTALLATION
1.
Strip wires of outer shell leaving 6mm (¼”) of bare wire.
2. Insert wire into terminal and tighten.
3. Repeat process for remaining wires.
Alarm Latch Feature:
This feature is user configurable. The Factory default is
ON. If set to ON, an alarm condition will require the user to reset the alarm to
return the system to normal condition. Alarm latch is rated for 10 Amps @ 250
VAC. Alarm relay coil will energize with an alarm condition.
Normally Open (NO):
Will close contacts on alarm condition.
Normally Closed (NC):
Will open contacts on alarm condition.
6mm (1/4”)
