Service & Troubleshooting Guide - Home Generator System - Models 040213 and 040234 (15kW)
Section 1 - General Information
Page 17
1
SYSTEM CONNECTIONS
Wiring For The 2-Pin Connector:
240 Volt Utility
- Use to hook up the 240V utility leads
from the transfer switch to the generator.
Wiring For The 10-Pin Connector:
Fault Contacts
- Use NO, COM and NC to hook up a
siren, light, etc. to alert you in case of a fault. Contacts
reverse state upon a fault condition.
Remote LED Output:
- Use this to hook up the remote
LED supplied with the generator. The remote LED will
turn on and off in a series of blinks if certain faults are
detected in the generator.
Transfer Switch Communication
- Use TxRx and TxRx
GND to transfer switch and optional wireless
StatStation
™
to monitor generator functions and for
FC_8 sensing.
+12 Volt DC, .5AMP Output
- Internal power supply
.
Fault Contacts
Transfer Switch
Communications
Remote LED Output
+12VDC,.5Amp Output
240VAC Utility
10 Pin Connector
2 Pin Connector
Summary of Contents for 40213
Page 3: ...Page 3...
Page 4: ...Page 4...
