Briggs & Stratton 276535, Repair Manual

Page: 16 / 38

2-Cycle Snow Engine
Section 3 - Engine Disassembly
Page 10
REMOVE FLYWHEEL
1. Remove flywheel nut and starter cup (Figure 20).
Fig. 20
2. Reinstall nut flush with the end of the crankshaft.
3. Remove the flywheel by pulling up on the edge of
flywheel while striking the flywheel nut with a soft
mallet (Figure 21).
Fig. 21
4. Remove key.
REMOVE OPTIONAL 120V STARTER
1. Remove the starter switch, the bolt holding the
wire clip, and the two bolts which mount the
starter to the engine (Figure 22).
Fig. 22
REMOVE MUFFLER
1. Remove the two bolts that secure the muffler
to the cylinder (Figure 23).
Fig. 23
2. Remove muffler and discard gasket.
3. Remove muffler re-enforcement plate (if installed).
0893-21
l0893-34
1657-017