Briggs & Stratton 276535, Repair Manual

Page: 15 / 38

2-Cycle Snow Engine
Section 3 - Engine Disassembly
Page 9
SECTION 3
ENGINE DISASSEMBLY
REMOVE SHROUD
1. Disconnect spark plug wire.
2. Remove the two screws that attach the shroud
to the base (Figure 17).
3. Remove the nuts and washers from the studs
(Figure 17).
Fig. 17
REMOVE CARBURETOR
NOTE
: We strongly recommend cleaning the
exterior of the carburetor before removal from
the engine.
1. Remove fuel line and drain; remove the fuel tank.
(On some snow throwers, it will be necessary to
remove the lower shroud to access the carburetor
and fuel line.)
2. Disconnect the primer tube from the carburetor
fitting and remove the choke cable.
3. Slide the air vane from its mounting bracket as
shown (Figure 18).
Fig. 18
4. Remove the two screws that secure the
carburetor to the intake pipe and discard the
gasket (Figure 19).
Fig. 19
5. Pull the carburetor assembly down and away from
the engine and set aside.
720-002