2-Cycle Snow Engine
Section 5 - Engine Assembly
Page 24
4. Torque rod screws to
70 lb-in. (8.0 Nm)
(Figure 68).
Fig. 68
5. Make sure that MAG side ball bearing is seated
against bearing surface
in cylinder
(Figure 69).
Fig. 69
6. Install snap ring into groove behind PTO ball
bearing. Push down on snap ring so that it is
seated in its groove (Figure 70).
Fig. 70
INSTALL OIL SEALS
NOTE
: Do not lubricate the seals. Install them
dry.
1. Slide seals over crankshaft and position them so
that they are centered over the grooves in the
cylinder crankcase
(Figure 71). Make sure
seals are not crooked or tilted in any way.
Fig. 71
Summary of Contents for 276535
