2-Cycle Snow Engine
Section 4 - Engine Overhaul
Page 15
CARBURETOR DISASSEMBLY
NOTE
: The exterior of the carburetor should be
cleaned before removal from the engine.
1. Using needle nose pliers, gently pull the throttle
plate
out of the throttle shaft (Figure 38). Note
the orientation of the small protrusions on the
throttle plate as you pull it out.
Fig. 38
2. Remove throttle shaft.
3. Set the choke lever to the full-open detent (Figure
39).
Fig. 39
4. Using needle nose pliers, gently pull the choke
plate from the choke shaft (Figure 40). Note the
orientation of the small protrusions on the choke
plate as you pull it out.
Fig. 40
5. Remove the four bowl retaining screws
, the
bowl gasket
, and the bowl
(Figure 41).
Discard the bowl gasket.
Fig. 41
Summary of Contents for 276535
