8.1. Delete the closed race from the ETS clock.
After the ETS clock has been disconnected from the Club
-
Master, the race will need to be
deleted in order for the chip rings that have recorded in the races to be freed up so that they
can be used in forthcoming races and training flights. (Follow the instructions of the ETS clock).
To delete a race from a
SPEEDY clock
the following routine should be employed:
1.
Insert the power supply directly into the base of the Speedy clock.
2.
Proceed to the
‘
Races
’
icon and press <OK> to view the active races within the clock.
The second line of each active race shows the club ID / race point and date/time opened.
Each of the active races is given a status number.
Status 1.
The race has been basketed.
Status 3.
The race has been read out but not closed.
Status 7.
The race has been read out and closed.
3.
Return to main menu by pressing <C> and proceed to the
‘
Delete
’
icon.
4.
Press <OK> and all races having status 7 will then be deleted.
NB :
If an active race is showing as status 3 where it was intended that it should have been
showing as status 7 simply repeat the read out procedure and carry out the instructions correctly.
Attention : If an active race can not be accessed through the Club
-
Master, check that the current
club ID of the club
-
master is the same as that of the club ID of the active race.
9. Progress Reading.
Circumstances may arise where you need to take a clocking list, but also wish to be able to
record further pigeons on the ETS clock at a later time. This may occur where an early pigeon
needs registering at the club, but other potential prize winners or pooled pigeons have yet to
return home from the race.
In these circumstances you should select main menu option 3 (Progress reading).
The Progress reading menu option operates under the same procedures as the read out
(menu option 2) but does not allow for the race to be closed until later.
10. Antenna Options.
Here you can read rings or repair rings.
Read rings
Place the ring in the basketing antenna, and the chip number and loft number appears on the
screen.
By pressing <OK> it is possible to read the next ring, whilst pressing <C> cancels read rings.
Repair rings
Occasionally the ring is blocked after the writing of data.
Press repair rings, and the master requests that the ring is placed in the basketing antenna.
The non
-
OTP part of the ring is set back to scratch, and the ring is ready to use.
BRICON CLUB
-
MASTER
32
