Fig.50
®
The retaining ring is installed in the upper body.
9.4.8
Installation of the shaft bushings in the lower body
Carry out the following steps:
1.
Insert the bushing (24) into the large hole in the centre of the lower housing
and press in with the special tool (SP6) until it stops.
Fig.51
2.
Insert bushing (22) with flange end upwards into the same hole. No tool is
required for this step.
®
The shaft bushings is installed in the lower body
9.4.9
Assembling of the upper and lower body
Prerequisite:
•
Before assembling, test if the drive shaft (18) can rotate across the gap.
Maintenance
Installation
430BAL011762EN_2
52
28.05.2018
