Fig.55
4.
Remove from the vice and insert the set screw (26) into the middle upper hole
in the lower body. Tighten with an Allen key (2.5 mm), see torque
Section 9.4.1, Page 45.
Fig.56
®
The upper and lower body are assembled.
9.4.10 Mounting the nozzle carrier
Prerequisite:
•
Make sure that key (29) is in groove on the spindle shaft.
Mounting the shaft and retaining plate
Carry out the following steps:
1.
Insert the output shaft (8) into the hole with the bushing. Make sure the
smooth end is inserted first and the threaded end protrudes. The feather key
should be oriented upwards as shown in the picture. This facilitates later
insertion of the pin driver.
Note:
When the shaft is inserted, air is displaced in the bore, giving the
impression of an air cushion.
Maintenance
Installation
430BAL011762EN_2
54
28.05.2018
