© 2020 Breckwell Hearth
5
the rear of the stove is necessary. The circuit board/control
panel must be unpacked and installed in the side flashing
on the insert. (See installation instructions provided with the
circuit board) NOTE: Normally, your dealer will perform
these functions.
IMPROPER INSTALLATION
The use of other components other than stated herein
could cause bodily harm, heater damage, and void your
warranty. The manufacturer will not be held responsible
for damage caused by the malfunction of a stove due to
improper venting or installation.
FLOOR PROTECTION
This heater must have a non-combustible floor protector with
an insulated rating of ‘R1’ installed beneath it if the floor is
of combustible material.
FRONT
LENGTH
WIDTH
Front
6” (153 mm)
Length
35” (889 mm)
Width
25” (635 mm)
CLEARANCES
This pellet stove has been tested and listed for installation in
residential, mobile home in accordance with the clearances
given below. This insert is approved for installation into
code complying masonry fireplaces. This insert is also
approved for use in listed factory built fireplaces (UL 127)
and standard residential built-ins, including mobile home
built-in installations.
C
A
A
*B
D
C
C
D
A
Side Wall to Stove
3”
77 mm
B
Back Wall to Stove
*2”
51 mm
C Wall to Vent Pipe
3”
77 mm
D
Stove Corner To Wall
3”
77 mm
* With Horizontal Exhaust
Com
bus
tab
le S
ide
Wa
ll
Man
tle
Side
Facing
Top F
acing
G
F
E
K
Non-Combustible
Hearth Extension
Floor Protector
Combustable Floor
H
J
E
6”
153 mm
F
5”
127 mm
G
14” 356 mm
H
10” 254 mm
J
3”
77 mm
K
0”
0 mm
OUTSIDE AIR SUPPLY
(OPTIONAL, UNLESS INSTALLING IN A
MOBILE HOME)
ATTENTION:
DO NOT VENT UNDER ANY PORCH, DECK, AWNING, OR
IN ANY SEMI ENCLOSED OR ROOFED AREA. DOING SO
MAY RESULT IN UNPREDICTABLE AIRFLOW AT THE VENT
CAP UNDER CERTAIN CONDITIONS AND CAN AFFECT
THE PERFORMANCE OF YOUR STOVE, AS WELL AS,
OTHER UNFORESEEABLE ISSUES.
Depending on your location and home construction, outside
air may be necessary for optimal performance. A 2” ID
metallic pipe (either flexible or rigid) may be attached to the
inlet at the stove’s rear. A rodent guard (minimum 1/4” wire
mesh)/wind hood must be used at the terminus.
INSTALLATION
Summary of Contents for SP24i
Page 31: ...2020 Breckwell Hearth 31 NOTES...
