25
If you experience a problem, please check the following again before consulting Brasseler USA.
If the problem cannot be remedied, please contact Brasseler USA. Contact Brasseler USA.
13. Troubleshooting
Recharge the batteries. If battery does
not fully discharge, charge will start. If
the batteries are fully discharge,replace
with new batteries
Insert batteries.
Contact Brasseler USA.
Replace with new batteries.
If the temperature of batteries is less
than 0°C (32°F), the batteries cannot
charge. Charge the batteries in a warm
room. (Be careful about moisture
condensation.)
If the temperature of batteries is more
than 40°C (104ºF), the batteries cannot
charge. Charge within the range of
working temperature. It is normal that
the batteries become a little bit warm
right after charging. If the batteries are
hot under normal operating conditions,
not right after charging, there may be
an abnormality. Contact Brasseler USA.
Check that no battery other than
Ni-MH battery is used.
Correctly set.
Remove metal on the charger.
See 12. Error Code.
Insert the power cord plug into the
outlet.
Insert the power cord jack into the inlet
on the charger.
Turn ON the power for the charger.
Contact Brasseler USA.
Batteries have fully discharged.
(Has the handpiece been left
with batteries inserted for a
long time?)
No batteries are inserted.
The internal fuse has burnt.
Batteries have been completely
discharged.
The temperature of batteries is
low.
The temperature of batteries is
high.
The voltage of a battery is too high
The motor handpiece is not
correctly set to the charger.
Metal such as wire or safety pin is
placed on the charger.
An error code is displayed.
The power cord plug is not
inserted into the outlet.
The power cord jack is not
inserted into the inlet on the
charger.
The power for the charger is OFF.
The fuse has burnt.
The power is
not turned on.
The battery
charger does
not work. (The
CHARGE
animation does
not display)
The battery
charger does
not work. (the
power for the
charger is not
turned ON)
Solution
Cause
Problem
Summary of Contents for EndoSequence II
Page 1: ...OPERATION MANUAL OM ER436E Cordless Handpiece...
Page 28: ......
