Brandt TG1120B, Manual For Installation And Use

Page: 7 / 20

7
48 cm mini
3 cm mini
30 cm
mini
26,5 cm
30 cm
m
ini
5,3 cm m
ini
70 cm mini
The hob must be built into the work-
top of a support cupboard. This work-
top must be at least 3 cm thick and
heat-resistant or else coated with a
heat resistant material.
A side-clearance of at least 30cm
should be left to the right and left of
the hob, 5.3cm from the rear wall.
And a side-clearance of at least 40cm
should be left to the right and left of
the burner, 12cm from the rear wall.
A tall cupboard or partition too close
to the hob would hinder free move-
ment of kitchen utensils.
If a horizontal partition is put under
the hob, it must be placed between
10 and 15 cm from the bottom of the
work top. In any case, do not keep
any sprays or pressurized containers
in the compartment which could be
just under the hob.
F
itting recommendations (cont'd)
Installing your hob in all simplicity
To ensure sealing between the cupboard
and the worktop follow points below :
1- Remove the pan support grates, the
burner caps and heads after checking
their position.
2 - Turn the hob over and place it gently
over the opening in the worktop paying
attention not to damage the control
knobs and lighters.
3 - Stick the foam seal around the out-
side of the hob .
4 - Put the hob back the right way up
and place the burners, caps and pan
grates back in position.
Seal