Brandt TG1120B, Manual For Installation And Use

Page: 15 / 20

15
• To ignite a burner, press down and
turn the knob anti-clockwise
until it
is pointing to the maximum
position
.
Keep the knob pressed down. This will
trigger off a series of sparks that will light
up the burner.
• Adjust the flame to the height your
require by turning the control knob
between the
and symbols.
• Each burner is controlled by a tap
fitted with a safety system, which cuts the
gas off automatically if ever the flame goes out
by accident (overflowing, drafts, etc.).
• The safety system for the burners is a metal
rod next to the flame.
• Your hob is equipped with an
automatic lighting system integrated into
each control knob.
• Choose the gas burner you need using
the symbols at the side of each control
knob; (E.g. back burner
).
Using your hob in all simplicity
H
ow to use your gas burners?
●
Lighting a hob F
ITTED WITH A SAFETY
DEVICE
To set off the safety system, keep the knob
pressed completely down for a few seconds
after the flame has lit up.
Do not use aluminium cover. Using aluminium
cover may cause abnormal combustion.
Sparker
Gas safety
device
- If ever your flame goes out, relight it as per normal procedure.
- The flames on the burner are smaller near the grate supports to avoid any damage being
done to the enamel.
- The noise made by certain burners is related to their power and burning gas; this
does not harm the quality of cooking in any way.
- Should there be an electricity cut, you can always light a burner using a match and by pres-
sing down on the control knob at the same time.