9
C
hanging the type of gas
supply (cont'd)
Change the injectors in the following way:
●
Remove the deflector by unscrewing the
two screws holding it in place (
fig.1
).
●
Remove the rear cover by
unscrewing the 11 attachment
screws (
fig.1
).
●
Unclip the metal tie located on the
base of the burner (
fig. 2
) using a
small screwdriver.
●
Remove the injector with the seal
which covers the tube.
●
Put the new injector adapted to
the gas on the tube with the
new seal.
●
Replace the tube and clip the metal
tie back on.
●
Screw the rear cover and the deflector
back on.
2B
- Changing the injector of the oven and
grill.
Joint
Injecteur
Tube
Attache métallique
Deflector
fig.1
fig.2
- You must imperatively replace
the seal on the aluminium tube
before fitting the new injector.
Seal
Tube
Metal tie
Injector
Natural gas OR Town gas
➡
➡
LPG
➡
Remove the knobs.
➡
Using a small screwdriver,
without forcing
screw
the brass screws of each tap (top and
oven).
➡
Replace the knobs, light each burner and gently set to the minimum position.
➡
Switch from full flow to reduced flow several times to check that the adjustment is correct.
3
- Adjustment of the minimal gas flow for
the taps of the hob burners and the oven
thermostat.
Installing your cooker : nothing is easier
99634212_GB_A.qxd 08/10/04 11:37 Page 9
