Software Reset:
ESC 0
- Soft Reset
This command is used to reset the Printer. It is
used from the computer and has the same effect
as pushing the key RESET PRINTER. Software
Reset should be used with care: If the printer
has not fi nished printing, the rest of the text in
the buffer will be lost, and a new paper position
will be assumed by the Printer. Because of this,
the command is only to be used after a software
form feed has been executed, and the Printer has
stopped completely.
ASCII
HEX
Software Reset
027 048
1B 30
Software Form Feed:
ESC 1
- Soft Form Feed
This command is to be used after all text in one
volume has been transmitted to the Printer. If
text corresponding to less than two pages, or text
with an odd number of pages is received, and
not followed by FF on the last page, the Printer
will wait for more text or FF. This means that
the last page may be stuck in the Printer. This is
due to the double-sided printing of the Printer.
This command makes the Printer to start print-
ing the rest of the text. After this the paper
position will be the same as it had when this
volume of text was started. Then page no. 1 on
the next volume will start out correctly. There
will always be at least one blank sheet of paper
between the volumes of text when fi nishing each
volume with a Software Form Feed.
ASCII
HEX
Software Form Feed 027 049
1B 31
BRAILLO
●
NORWAY AS
B 400 Series 3
93
Summary of Contents for 400 S 3 Series
