4.16 Main sensor wheel, adjustment
The main sensor wheel is placed on the lower shaft, on the opposite end from the belt.
Turn the belt in the
opposit
direction of normal rotation (see (A) on the fi gure below), until the
papershoes just meet (see (B) on the fi gure below). Do not press !
The edge on the timing wheel should now be placed exactly like position (C) in the fi gure below.
If the edge is not in it’s correct position, it must be adjusted.
Keep the shafts in this position while loosen the two screws holding the timing wheel. Turn the timing
wheel until the edge on the wheel is placed in the middle of inductive sensor. Then fasten the two
screws again.
A
C
B
BRAILLO
●
NORWAY AS
B 400 Series 3
63
Summary of Contents for 400 S 3 Series
