6.7 Pin confi guration serial and parallel port
Data transmission from the computer to the printer can be done in two ways, either serial or parallel.
The serial goes through an RS 232 C interface, and the parallel is using a Centronics compatible
interface. Both connectors are of the 25 pin D-sub type.
Pin confi guration 25 pin male D-sub contact RS 232 C (serial port):
Pin no. 1
FG
Frame Ground
Pin no. 2
Tx
Transmit data
Output
Pin no. 3
Rx
Receive data
Input
Pin no. 4
RTS Request to send
Output
Pin no. 5
CTS Clear to send
Input
Pin no. 6
DSR Data set ready
Input
Pin no. 7
GND Signal ground
Pin no. 8
DCD Data carrier detect
Input
Pin no. 9
PU
+ 12V (Logic high)
Output
Pin no. 20
DTR Data terminal ready
Output
The printer is only using pin no. 4 (RTS) as a control signal. When this is set to logic low (from
the printer), the computer must stop sending text immediately. Pin no. 2 (Tx) is used to transmit
XON/XOFF control signals to the computer. The text sent to the printer is received through pin no. 3
(Rx). All other outputs from the printer are set to logic high.
Wiring diagram for the enclosed serial cable
Standard RS 232 C cable, 25-25 pin:
25 pin female
25 pin female
1
FG
FG
1
2
TD
RD
3
3
RD
TD
2
4
RTS
CTS, DSR
5,6
5,6
CTS, DSR
RTS 4
7
SG
SG
7
8
DCD
DTR 20
20
DTR
DCD 8
BRAILLO
●
NORWAY AS
B 400 Series 3
87
Summary of Contents for 400 S 3 Series
