When the arrows at the end of the shafts are pointing in the opposite direction of each other, the short
pivot arms will be approx. positioned like in the fi gure below:
The gap between the long and the short pivot arm should be approx. 0.2 mm.
When adjusting this, make sure that the gap is even for all the pivot arms and the same on both ends
of the magnet rack.
How to adjust:
Observe that the screw for horisontal adjustment will not pull the magnet rack outwards, they will
only push inward.
So the best way of doing this, is to loosen the four fastening bolts holding the magnet rack. Then
unscrew the horisontal adjustment screw a little. Now slide the magnet rack outward from the printer,
so it touches the horisontal adjustment screws again. Then thighten the four fastening screws just a
little so the magnet rack is held fi rmly in place, but is still able to move. Use the horisontal adjustment
screw to move the magnet rack closer to the printer. If this is done in small steps, it is possible to
watch the gap getting smaller, and the trick is to stop just before the long pivot arm is touching the
short pivot arm.
When the position is correct, thighten the four fastening bolts.
Approx. 0.2 mm
(As close as possible
without touching
when the short pivot
arm is moving up and
down).
Screw for horisontal
adjustment
BRAILLO
●
NORWAY AS
B 400 Series 3
51
Summary of Contents for 400 S 3 Series
