Braillo 400 S 3 Series, User Manual

Page: 15 / 97

2.6 Turn on the printer
After the mains cable and the serial/parallel cable has been connected, the printer on can be turned on.
For safety reasons, there are switches on each side panel on the cover. These switches
will turn the printer off if somebody is removing the side panels.
However, when doing service and maintenance it is possible to bypass these safety switches.
It is done with the key switch on the electric unit. See fi gure below:
If this key switch is turned to:
“Disabled” The safety switches and the On/Off switch is bypassed and the printer will stay on
independent of the On/Off switches. The Main switch can be used to turn the printer on
and off during service and maintenance .
“Enabled” This is the
normal position
. Now all four sidepanels has to be in place and the printer
is turned on and off with the On/Off switches.
Turn on the main switch. It will now be illuminated. This switch can normally be left on all the time.
Put the side panels on the cover back on.
Press the green “on” switch beside the operator panel. The switch will become illuminated, and there
will be background lights in the display.
Then the printer will do a little “startup procedure” (the paper feed tractor will move a little back and
forth). If there is no paper inserted, the printer will start to “beep”, and the display reads “Printer Out of
paper”. This is normal, and the noise can be silenced by pressing the button marked “Reset Alarm”.
The printer is now ready. Now please read the following chapter 3, “Operating” carefully.
1234567h
Mains
Fuses
10 AT
Safety
Switches
3.15 AT
Fan Fuse
Disabled
Enabled
Fan
Outlet
Mains
Inlet
2.5 AF
Magnet Rack Fuses, 3.15 AT
1234567h
2.5 AF
Voltage
Control Main Switch Relay Control
Voltage
2.5 AF 2.5 AF
Fuse
Counter
Hour
A B C
Board
Fuse
Ext.
Conn.
D
Key
switch
Main
switch
BRAILLO
●
NORWAY AS
B 400 Series 3
15