3.1 Inserting paper
Paper should be inserted into the printer in the following manner:
1.
Press the “on” switch, if the printer is not already switched on. (Green power lamp lights up).
2.
Place a box of paper on the paper shelf at the back of the printer. (Opposite side from the
operating panel).
3.
4.
5.
6.
Go to the back of the printer, and adjust the two paper guides carefully close to the edge of the
paper. This is to ensure that the paper will go straigth trough the printer.
7.
Push RESET PRINTER.
8.
Push RESET COUNTER, if desired.
9.
The printer is now ready to start printing.
Insert the paper between the two paper guides, and then through the slit in the paper guide.
Insert about the length of one sheet. Go to the front of the Printer.
The tractors migth have to be adjusted sideways to fi t to the paper width in use. This is done by
loosening a little red screw at the front of the tractors, then move the tractors so it will fi t to the
paper width, then thigthen the little red screw again.
Lock the paper into the tractor-feed. By using the FINE ADJUST button, adjust the paper
with respect to the starting mark (notch) corresponding to the chosen sheet length. (See fi gure
below).
Note! If the printer has run out of paper during a printjob, perform step 2 to 5, without
resetting the printer. Press the TEST PRINT button in and out, and the printer will continue
from the place where it ran out of paper without losing any text.
3. OPERATING THE PRINTER
BRAILLO
●
NORWAY AS
B 400 Series 3
16
Summary of Contents for 400 S 3 Series
