Page
31
- Installation Manual
24805490/11-01-2013 319F90C
ver
.
1.2 -
The data and information in this manual may be changed at any time with no obligation on BRAHMS’
s par
t t
o notify anyone of this
ENGLISH
ACQUIRING REMOTE INSERTERS
The system cannot have inserters with the same address.
STEP 1: Activating inserters in the control unit
1.
To access the Technical Menu, press the
/ESC # key for 5 sec
followed by the User code (if under 6 digits confirm with
*
).
2. Press
the
/ESC # key for 5 sec and enter the Technical code.
3. With
select
SYSTEM
and press
*
.
4. With
select
CHANGE SYSTEM
and press
*
.
5. Using
select
INSERTERS
.
6.
Use the number keys to select and activate inserter (# = activated, -
disactivated).
7. Press
#
to return to the previous menu.
STEP 2: Addressing the inserter
To assign an address to an inserter you need to:
1.
Staying inside the menu
SYSTEM
.
2. With
select
ADDRESSING INSERTERS
and press
*
.
3.
The display shows the inserter address which was not found on bus
and which needs to be addressed.
4.
Using a key (even one not accepted) approach the inserter to which
you wish to assign the address which appears on the display and
wait for the LED lights to flash slowly and for the buzzer to sound.
5.
The display will show
INSERTER 02 OK
. Press
*
to continue.
6.
If there are other inserters to address, the procedure would restart
from the beginning.
7. Press
#
to exit and return to the previous menus.
All of the inserters are made with address 1 and the control units have a built-in factory enabled inserter.
To address and acquire a new inserter from the control unit you need (example of added inserter 2):
08:23 16/05/10
ENTER CODE
123456
STANDING BY
*=USER MENU
222222
SYSTEM 02
CHANGE
SYSTEM
*
▼ ▲
▼ ▲
INSERTERS
-----
▼ ▲
*
INSERTERS
-----
#
2
08:23 16/05/10
ENTER CODE
123456
STANDING BY
*=USER MENU
222222
SYSTEM 02
ADDRESSING
INSERTERS
*
▼ ▲
▼ ▲
SELF-LEARNING
KEY READERS..
▼ ▲
*
INSERTER OK
PRESS */OK
*
