UNI EN ISO 9001-2015 n° 9115.BRMO
USER MANUAL
“Aquarius Plus”
File name
Date
Page
Code
PUT9I001 PUT9I1K5
DF19009A
05/04/19
18
di
32
PUT9I002
PUT9I003
MD03006C
- All rights are reserved according to the law. Reproducing or distributing this document to third parties without permission is prohibited.
5.4
operation
5.4.1
UPS start-up
Starting the UPS, the Line Mode.
Once the mains supply is connected, the UPS charges the batteries. The display will show that the
output voltage is 0, which means that UPS cannot yet power the load. If you plan to use the bypass,
you can set the bps "ON" from the LCD settings menu.
To start the UPS, hold down the ON button for more than half a second. When the time expires the
inverter will start up.
Once started, the UPS will perform a self-test. The LEDs will turn on and off in a circular and orderly
manner. At the end of the initial test the device will be active and the Line Mode, with the relative
LED lit.
Starting the UPS in battery mode.
To start the UPS even in the absence of mains, keep the ON key pressed for more than half a
second. When the time expires, the inverter will start up.
The start-up of the group is identical to the Line Mode, at the end of the self-test the Battery Mode
LED will light up.
5.4.2
Turn off the UPS
To turn off the UPS, press and hold the OFF button for more than half a second. When the time
expires, the UPS and inverter will shut down.
After switching off the inverter there will be no output voltage left. In this situation it is possible to
activate the by-pass (bps on) function to equally power the load.
The same shutdown procedure, it is possible to use it even when the group is in absence of network
in battery mode.
