Boston Whaler 370 Outrage, Owner'S Manual

Page: 91 / 204

3-11
Section 3 • Systems & Components Overview & Operation
370 Outrage
R
Section 3 • Systems & Components Overview & Operation
OUTLETS
A/C
On/Off Start
Stop
Alarm
Mute Next
Screen
Set
SUMMER
GALLEY
WATER
HEATER
MICROWAVE
SHORE POWER 1 120V 60HZ
FISHBOX
FREEZER
A/C PUMP
PORT IGNITION
OF
F ACC ON
S
TA
R
T
OF
F ACC ON
S
TA
R
T
STARBOARD IGNITION
OF
F ACC ON
S
TA
R
T
CENTER IGNITION
NOTE: RUN BLOWER
BELOW CRUISE
SPEED.
Master Key Switches
Fig. 3.11.1
1
2
AC DISTRIBUTION PANEL
PORT ENGINE KEYSWITCH
CENTER ENGINE KEYSWITCH
STARBOARD ENGINE KEYSWITCH
1
2
3
4
3
4
The “ACTIVE” light located
on the throttle remote pad
will become illuminated once
the engines are started and
communicating with the throttle
control.
NEUTRAL
TROLL
SYNC
TRANSFER
1 LEVEL
THROTTLE
ONL
Y
DOCK
NEUTRAL
TROLL
SYNC
TRANSFER
1 LEVER
THROTTLE
ONL
Y
DOCK
Warming Up the Engines
The “THROTTLE ONLY” button on the throttle
control pad allows the operator to increase engine
RPM for warm-up without shifting the engines into
gear.
• B e s u r e t h a t t h e
gear shift and throttle
control levers are in the
NEUTRAL position.
NEUTRAL
TROL
L
SYNC
TRANSFER
1 LEVEL
THROTTLE
ONL
Y
DOCK
Stopping the Engines
• Be sure that the gear
shift and throttle
controls are in the
NEUTRAL
position.
• Press the start/stop
b u t t o n o n t h e
ignition pad for
the appropriate
engine.
REFER TO THE OWNER’S MANUAL IN YOUR OWNER’S
MANUAL PACKET FOR COMPLETE INSTRUCTIONS
AND WARRANTY.
NEUTRAL
TROL
L
SYNC
TRANSF
ER
1 LEVEL
THROTTLE
ONL
Y
DOCK
TRIM
UP
DN
PORT MID STBD
START
STOP
START
STOP
START
STOP
ERCURY
• Press and hold the “THROTTLE ONLY“
button while moving the control handle
ahead to the forward position.
• Hold in the button until the horn sounds
t w i c e a n d t h e n e u t r a l l i g h t s s t a r t
flashing. The flashing lights indicate
that throttle only is engaged.
• Advance the control handles to increase
engine RPM.
NOTE: Engine RPM is limited to prevent
engine damage.
• To disengage, return the control handles back
to the neutral position.
The warm-up mode can be re-activated by turning
the engines off and re-starting.