Boston Whaler 370 Outrage, Owner'S Manual

Page: 194 / 204

5-6
Section 5 • Care & Maintenance
R
370 Outrage
Single component Acrylic Enamel (spray enamel)
touch-up paint is commonly used for repair of minor
damage in the powder coated fi nish. In some cases
a two-component catalyzed paint system may be
required to achieve the desired repair. In all cases,
perform a color and adhesion test in an inconspicuous
area of the fi nish to assure compatibility before
applying the paint to the damaged area.
Touch-up Procedure
• CLEAN surface of dirt, oil, grease, etc.
• SAND LIGHTLY with 400 grit wet/dry
abrasive paper.
• REMOVE sanding dust with a lint-free cloth
dampened with mineral spirits.
• TEMPERATURE of surface and paint must
be at room temperature (between 70 to 90
degrees is ideal).
• APPLY paint to minor scratches by spraying
a small amount of paint into the container’s
cap. Using a small brush, carefully apply the
paint sparingly to the properly prepared
surface. DO NOT APPLY A HEAVY COAT
ALL AT ONCE. Apply several light coats
allowing the paint to dry until tacky between
each coat.
Maintaining a good appearance
• After each use, especially if used in salt
water areas, rinse the canvas completely
with fresh cold water.
On a regular basis
• Brush off any loose dirt, pollen, etc.
Canvas Care and Maintenance
To keep your canvas and metal parts in good working
condition and in good appearance, you will need to
keep them clean.
The fabric should be cleaned regularly before
substances such as dirt, pollen, etc. are allowed to
accumulate on and become embedded in the fabric.
The canvas can be cleaned without being removed
from the installation.
Chafi ng, fi ber wear from dirt and grit and deterioration
from ultraviolet light can cause your canvas to
degrade over time.
NOTICE
DO NOT use detergents, bleach or solvents to
clean your canvas.
NOTICE
If painting over exposed or bare metal, a
chemical pretreatment process and/or primer
sealer is recommended.
Follow manufacturer’s recommendations.
NOTICE
The visual, mechanical, chemical as well as
corrosion protective and weather resistance
properties of repaired areas ARE NOT equal to
those of the original powder coating and are not
suitable for long term performance.
FOR MORE INFORMATION, CONTACT APEX POWDER
COATING, INC CUSTOMER SERVICE AT 1-864-288-2739
NOTICE
It is highly recommended that you DO NOT
penetrate the powder coating on your boat
by securing equipment or other objects onto
the coated surface. If necessary, contact the
manufacturer for repair recommendations.
NOTICE
For the best results, use Orbit Industries
touch-up paint, RAL 9010 Pure White.
Orbit Industries: 1-800-448-3885