Boston Whaler 370 Outrage, Owner'S Manual

Page: 141 / 204

3-61
Section 3 • Systems & Components Overview & Operation
370 Outrage
R
Section 3 • Systems & Components Overview & Operation
HORN MAP
LIGHTS
NAV/ANC
LIGHTS
CTSY
LIGHTS
FWD SPDR
LIGHTS
AFT SPDR
LIGHTS
WINDLASS
ON/OFF
WINDLASS
UP/DOWN
FWD
BILGE
AFT
BILGE
EMC
BILGE
VENT
Propeller Pitch & Diameter
Fig. 3.61.1
PITCH
DIAMETER
1
2
1
2
!
DANGER
Disconnect power by moving the battery switch
to the “OFF” position prior to removing the
propeller.
Propeller Assembly
Fig. 3.61.2
1
2
3
4
5
6
7
8 ENGINE SHAFT
FORWARD THRUST WASHER
DRIVE SLEEVE
INNER HUB
BLADE BACK
OUTER HUB
EXHAUST PASSAGE
DIFFUSER RING
PROP NUT
LOCK RING
DRIVE SLEEVE ADAPTER
BLADE TIP
LEADING EDGE
TRAILING EDGE
BLADE FACE
9
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
10
11
12
13
14
15
Anchor Windlass
Use the windlass switch on the helm whenever
possible. Use care when operating the anchor
windlass with the hand-held remote.
!
DANGER
The anchor windlass located at the bow gives you
a mechanical means of raising and lowering the
anchor.
The anchor windlass is controlled by switches located
on the helm switch panel or by a hand held remote
located in the bow locker.
The ON/OFF switch on the helm switch panel
controls power to the windlass.
The operation switch is a momentary type switch which
means that there must be constant pressure applied to
the switch to operate the anchor windlass.
When not in use, the remote can be stored in a
receptacle located on the aft bulkhead of the bow
locker. The power source for the remote is located
on the starboard side of the locker.
There is also an emergency handle which can be used
to raise and lower the anchor manually in case the
power to the anchor windlass is lost.
Windlass Switches
Fig. 3.61.3
1
2
3
WINDLASS POWER SWITCH
WINDLASS OPERATION SWITCH
HELM SWITCH PANEL
1 2
3