Bosch Rexroth PSI 6100 L1 Series, Operating Instructions Manual

Page: 428 / 460

1070080028 / 08 Bosch Rexroth AG PSI 6xxx | 428 /460
Troubleshooting
Examples of self‐resetting faults include:
-
Stop / No 24V
- Power voltage off / too low
- Synchronization / mains / DC-link voltage error.
”Non-self-resetting” faults can be reset via
•
the BOS software
• a positive edge at the fault reset inputs of the I/O array of the weld
timer
• the RESET button on the timer's front side (for PSI 6x00)
• the diagnosis module (for PSI 6xCx)
The "Heat sink temperature too high” and ”Overcurrent or earth fault”
errors must always be manually reset via the RESET button or on the
diagnosis module.
Example of a fault: Temperature monitoring responds
1.
The integrated power unit indicates temperatures greater than/
equal to 65
°
C (+5
°
C) to the integrated weld timer.
2.
As a result, the weld timer stops all further sequences.
3.
The ”Power unit temperature” error is displayed.
Possible cause Action
Contaminated heat sink. Clean heat sink.
Ambient temperature too high. Check installation area cooling for
proper installation and functioning.
Rating of the power unit too low. Calculate duty cycle and check
selection on the basis of the load
diagram.
Cooling water too warm or cooling
water flow too low. Check flow and/or temperature of
cooling water.
Forced ventilation of air‐cooled units
is defective. Check forced ventilation.
English