DT800(E75) Lane Timer Instruction Manual
Features:
1) 8000 Memories
2) Built-in PRINTER
3) Up to10 Lane Buttons
4) PC Upload Function
5) 12
/
24Hr User-selectable Clock
6) 4-Digit Bib Number
7) 4-Digit Place Counter
8) 2-Digit Lap Counter
9) Auto Print Out
10) Print Final Result Function
11
)
Pre-Entry of Bib Numbers in Track Races
12) Single and Multi Start Times for Road Races
13) Maximum 99 Waves
14) Race Recall Function
15) Memory Clear Function
16) Printing Pause Function
17) Key Operation Sound
18) AC or DC operated, AC adaptor enclosed
Battery installation:
In the DT800(E75) Lane Timer two types of batteries are used -- 4 pieces of 1.5V AA size
alkaline battery and 1 piece of CR2032 Lithium battery. The AA size alkaline batteries
supply the power for both printer and CPU. The 3V CR2032 battery is for back up purpose.
Printing is not available when only the CR2032 battery is installed.
To replace batteries remove the battery lid as shown in Fig.1. Replace the AA size
alkaline batteries according to the polarities shown on the case. To replace the CR2032,
unscrew the positive metal contact and replace the battery into the position shown in Fig.
1 with positive side face up. Re-screw the metal contact.
**: Always replace at the same time with all 4 pieces of new AA size high capacity
alkaline batteries.
You do not need to reset the Timer if the clock keeps running after changing of batteries.
If all batteries are dead and the clock is out of order, you need to press the reset key Fig.
1 to reset the Timer after battery replacement. During reset or power up, all display
segments will be turned on for 2 seconds. The timer will then switch to clock mode
automatically. Slide back the battery lid to complete the battery replacement procedure.
**: Remove all the AA size alkaline batteries if the Lane Timer will not be used for a
long time to avoid battery leakage that may damage the timer.
1
