Bosch Rexroth PSI 6100 L1 Series, Operating Instructions Manual

Page: 366 / 460

1070080028 / 08 Bosch Rexroth AG PSI 6xxx | 366 /460
Assembly
7.2.7 24 V
DC
voltage generator (X4, output)
Connection: to X4; STKK, grid 3.5 mm, 14-pole,
max. 1.5 mm
2
.
Mating connector is comprised in the delivery.
Cable length: (from power source to consumer)
max. 10 m at 0.75 mm
2
max. 75 m at 1.5 mm
2
Cable type: unshielded, VDE 0281, 0812 (e.g.: Ölflex)
A 24 V
DC
voltage supply is available at X4 which is derived from the line
voltage by the power unit.
Power supply by the internal 24 V
DC
voltage generator and thus the
operativeness of the devices supplied by it is ensured only if line
power is supplied to to the line input of the power unit!
Timer
0 V
X4
5
8
+24 V
DC
Can be used, e.g., for supply­
ing the control logic and the
I/O module.
Fig.69: Internally generated 24 V
DC
voltage supply
" When using the internal 24 V
DC
voltage generator, the following
notes should be observed:
• For technical data, refer to page 431.
• For power supply to control logic:
When the line voltage is switched off at the line input of the power
unit, the timer is also turned off. In this state
• programming, diagnosis or visualization via the timer, and
• communication are no longer possible between the timer and
the PLC/robot.
• For power supply to the I/O module:
When the line voltage is switched off at the line input of the power
unit, the I/O module is also turned off. In this state
• communication is no longer possible between the timer and
the PLC/robot via the discrete signals.
"
If these conditions are not suitable for your application, the 24 V
DC
supply to the timer and/or the I/O module must be provided by
external power supply units!
English