Bosch Rexroth CS660, Calibration Manual

Page: 7 / 31

7/27
Bosch Rexroth Canada I March 2021 ı Revision 3.0
Note: Only one preferred network can be stored at a time, or this will cause a conflict!
If a preferred network already exists, please ensure you have firmware version 6 or higher installed and
do the following:
 Close the Wifi setup dialogs shown on the right so you are back to the setup screen.

Press and hold the WiFi network icon for 5 seconds to clear any preferred networks.
 Now you can perform the WiFi setup.
Note : Any changes to WiFi/ Network settings/ Time/Screen recalibration need to be saved by clicking the
save icon on the bottom of the screen.
2.2 Input and Output Configuration
To configure appropriate inputs or outputs press the additional options icon to set up I/O Mapping.
Note: the RC controller wiring must match what is chosen here.