20/27
Bosch Rexroth Canada I March 2021 ı Revision 3.0
3.8 Lane Control
The conveyor and spinner motor sizes and flow rates should be chosen as to limit the number of lanes
the system can actually cover before lane calibration takes place.
1.
Tap on the “spinner” icon to enter into spinner menu, and select “Half Lane” or “One Lane”
2.
Press “Start” Button.
3.
Spinner will begin to output, and arrows will appear to allow you to increase/decrease the speed.
You may also turn the center knob to activate the conveyor.
4.
Use the arrows to set the desired speed to spread material to half lane or one lane width.
5.
Press “Stop” to end the calibration and save calibration value.
3.9 (
4 knob
) Sp 1Boom Anti-ice
This configuration utilizes a 4 knob console, and control a spreader (spinner, conveyor, prewet) and a
1boom anti-ice simultaneously.
Steps to set up
-
Move gate to max opening
-
Press Max value to highlight
-
Record sensor position
-
Set max gate height
-
Press Max value again to save
-
Move gate to min opening
-
Press Min value to highlight
-
Record sensor position
-
Set min gate height
-
Press Min value gain to save
Steps to set up
-
Up/Dn to move gate to max
-
Move gate to max opening
-
Press Max value to highlight
-
Record sensor position
-
Set max gate height
-
Press Max value again to save
-
Up/Dn to move gate to min
-
Move gate to min opening
-
Press Min value to highlight
-
Record sensor position
-
Set min gate height
-
Press Min value gain to save
Summary of Contents for Rexroth CS660
