Bosch Rexroth CS660, Calibration Manual

Page: 25 / 31

25/27
Bosch Rexroth Canada I March 2021 ı Revision 3.0
6 Set Up Error Messages
Error Messages # Suggested Solution
01-BLAST TOO LONG 1 Blast held too long
02-LIQ BLST TOO LONG 2 Liquid blast held too long
03-OVER SPEED 3 Slow down, reset max speed
04-ERR SPN OUTPUT 4 Check cables, check coil
05-ERR CONV OUTPUT 5 Check cables, check coil
06-ERR CRS1 OUTPUT 6 Check cables, replace coil
07-ERR CRS2 OUTPUT 7 Check cables, replace coil
08-NO GRANULAR DET 8 Load material, check sensor
09-NO LIQUID DET 9 Load material, check sensor
10-NO GROUND SPEED 10 Check cable/sensor
11-NO CONV FEEDBACK 11 Check cable/sensor
12-NO WET FEEDBACK 12 Check cable/sensor
13-NO LIQ FEEDBACK 13 Check cable/sensor
Warning Messages # Suggested Solution
21-UNLOAD NOT ALLOWED 21 Vehicle needs to be stationary
22-SYSTEM ERROR !!! 22 Reboot, or re-flash
23-NO RC,CHK FUSE/CONNECTION 23 Comm failure between display and RC
24-LIQUID BOOM OPERATION ERROR 24 Need at least one boom to work
25-NO JOY1,CHK CONNECTION 25 Comm failure between RC and Joy 1
26-NO JOY2,CHK CONNECTION 26 Comm failure between RC and Joy 2
27-NO GATE POS SENSOR 27 Check gate sensor, cable break
28-GATE CLOSED 28 Gate closed in READBACK mode
29-NO SIMULATE 29 Speed Simulation mode stopped
30-SPN UNDER APP 30 Spinner not able to reach desired RPM
31-SOLID UNDER APP 31 Rate or spd too hi, incorrect calib
32-PREWET UNDER APP 32 Rate or spd too hi, incorrect calib
33-LIQ UNDER APP 33 Rate or spd too hi, incorrect calib
37-GND SPD CALIBRATION 37 Too few or no pulses, recalibrate
38-SPINNER CALIBRATION 38 Bad or no sensor
39-CONVEYOR CALIBRATION 39 Bad or no sensor
40-PREWET CALIBRATION 40 Too few pulses, or sensor failed
41-LIQ CALIBRATION 41 Too few pulses, or sensor failed
42-SPN CAL: WRONG CTRL MODE 42 Auto null not allowed for MAN mode
43-CNV CAL:WRONG CTRL MODE 43 Auto-null or calibration not allowed
44-PREWET CAL:WRONG CTRL MODE 44 Auto-null or calibration not allowed
45-LIQ CAL:WRONG CTRL MODE 45 Check Anti-icing or CrsCnv modes
46-CRS CNV CAL:WRONG MODE 46 Check Cross-Conv mode setting
47-CALIBRATION ERROR 47 Check sensor, recalibrate
48-CALIBRATION ERROR 48 Check sensor, recalibrate
xx-CALIBRATION ERROR 49
.
.
70
Check sensor, recalibrate