22/56
Transport and storage
Bosch Rexroth AG
, A2FM/A2FE/A2FMT Series 70, RE 91071-01-B/06.2018
wARnInG! Danger from suspended loads!
During transport with a lifting device, the axial piston unit can topple out of the
lifting strap and cause injury.
▶
Use the widest possible lifting strap.
▶
Make sure that the axial piston unit is securely fixed with the lifting strap.
▶
Only guide the axial piston unit by hand for fine positioning and to avoid swinging.
▶
Never stand or put your hands under a suspended load.
▶
Place the lifting strap around the axial piston unit in such a way that it does not
pass over assembled parts (e.g. valves, piping) and that the axial piston unit is
not suspended from assembled parts (see Fig. 5).
Fig. 5: Transporting with lifting strap
6.2 Storing the axial piston unit
• Storage areas should be free of corrosive materials and gases.
• To prevent damage to the seals, do not operate ozone-forming equipment (e.g.
mercury-vapor lamps, high-voltage equipment, electric motors, sources of electrical
sparks or electrical discharge) in storage areas.
• Storage areas should be dry.
Recommended relative humidity ≤ 60%.
• Ideal storage temperature: +5 °C to +20 °C.
• Min. storage temperature: -50 °C.
• Max. storage temperature: +60 °C.
• Keep out of direct sunlight.
• Do not stack axial piston units and store them in a shock-proof manner.
• Do not store the axial piston unit on the drive shaft or on assembled parts, e.g.
sensors or valves.
• For further storage conditions, see Table 10.
▶
Check the axial piston unit monthly to ensure proper storage.
Transport with lifting strap
Requirements
