68
en | Configuration via IP, Advanced Mode
Dinion IP Infrared Imager
F.01U.263.416 | 3.1 | 2012.09
User Manual
Bosch Security Systems, Inc.
1.
Enter the IP address of the required iSCSI destination in
the
iSCSI IP address
field.
2.
If the iSCSI destination is password protected, enter this
into the
Password
field.
3.
Click the
Read
button. The connection to the IP address
will be established. In the
Storage overview
field, you can
see the corresponding logical drives.
Activating and Configuring Storage Media
The storage overview displays the available storage media. You
can select individual media or iSCSI drives and transfer these to
the
Managed storage media
list. You can activate the storage
media in this list and configure them for storage.
1.
In the
Recording media
section, the
iSCSI Media
tab will
display the applicable storage media in the overview.
2.
In the
Storage overview
section, double-click the required
storage medium, an iSCSI LUN or one of the other
available drives. The medium is then added to the
Managed storage media
list. In the
Status
column, newly
added media are indicated by the status
Not active
.
3.
Click the
Set
button to activate all media in the
Managed
storage media
list. In the
Status
column, these are
indicated by the status
Online
.
4.
Check the box in the
Rec. 1
or
Rec. 2
to specify which data
stream should be recorded on the storage media selected.
Rec. 1
stores Stream 1,
Rec. 2
stores Stream 2. This
means that you can record the standard data stream on a
hard drive and record alarm images on the mobile CF card,
for example.
5.
Check the boxes for the
Overwrite older recordings
option to specify which older recordings can be
CAUTION!
Each storage medium can only be associated with one user. If a
storage medium is already being used by another user, you can
decouple the user and connect the drive with the camera.
Before decoupling, make absolutely sure that the previous user
no longer needs the storage medium.
