Bosch I 8 OptiMUM Series, Information For Use

Page: 24 / 140

en Scales
24
10.2 Weighing ingredients
Requirements
¡
The bowl is inserted or an access-
ory is fitted.
¡
The rotary switch is set to ⁠.
¡
The display is activated.
1.
Press and do not touch the ap-
pliance again.
a
The scales will be calibrated.
a
The display shows "- - - - -".
2.
Wait for calibration to finish.
a
The display shows "0 g" or
"0.00 lb".
3.
Add the required ingredient.
a
The display shows the weight.
4.
To weigh further ingredients, select
one of the following options:
‒
Add further ingredients and read
off the total weight.
‒
Repeat the process and weigh
the ingredients individually.
10.3 Presetting the weight
Requirements
¡
The bowl has been inserted.
¡
The rotary switch is set to ⁠.
1.
If the display is switched off, press
any button.
2.
Press and do not touch the ap-
pliance again.
a
The scales will be calibrated.
a
The display shows "- - - - -".
3.
Wait for calibration to finish.
a
The display shows "0 g" or
"0.00 lb".
4.
Press ⁠.
a
The display shows "100 g" or
"0.20 lb".
5.
Use or to set the required
weight.
6.
Add the required ingredient to the
bowl.
a
The display shows the quantity by
which the weight is short, e.g.
65 g.
a
A recurring signal tone will sound
from a short weight of 40 g or
0.08 lb.
7.
Continue adding the ingredient
little by little.
a
The lower the weight that is short,
the faster the signal tone will
sound.
a
When the preset quantity is
reached, the signal tone will stop.
8.
Note: If the preset quantity is ex-
ceeded, the signal tone will sound
continuously. The display shows
the excess weight added as a neg-
ative value, e.g. -40 g.
Take the excess weight added
away again.
9.
To end weighing, press and hold
or start processing.
Tip:
You can change the volume of
the signal tones at any time.
→ "Overview of basic settings",
Page 21
10.4 Resetting scales
If an error message appears or unac-
customed measured values are dis-
played, reset the scales.
1.
Press and hold ⁠.
a
The display shows "OptiMUM"
2.
To restart the scales, press ⁠.
Note: If the scales still do not work
properly, disconnect the appliance
from the power supply for a while
and then start the scales again.