1 689 989 485 | 2020-08-01
Robert Bosch GmbH
1
2
3
1
2
3
4712005-36_shd
(1) Hex nut
(2) Washer
(3) Holder for laptop/tablet
---Separator---
4.6
Screwing in the retaining hooks for
the contact plate (CTA 104-x)
Screw the retaining hooks into the holes in such a way
that they point up.
4712009-12_shd
11
(1) Retaining hooks
---
4.7
Installing the KTS mount
The mount for the KTS 560/590 can be installed
on the DAS 3000 S20. The mount is part of the
scope of delivery of the KTS 560/590.
---
1. If the "Multi-Target-Shop" box is already installed, re‐
move it from the trolley.
2. Use pan head screw
ISO 7045-M4 x 6
and hex nut
ISO 4032-M4
to attach the mount for the
KTS 560/590 to the trolley.
Do not use longer screws for fastening. Longer
screws will damage the Multi-Target-Shop box
while it is attached to the trolley.
1
222
4712009-03_shd
(1) KTS 560/590 mount
(2) Pan head screws ISO 7045-M4 x 6
---
4.8
Install the USB connecting cables in
the camera beam (DAS 3000 S20 S20
only)
1. Remove the long cover
(1)
and short cover
(2)
from
the profiled slot.
2. Place the USB connecting cables
(3)
for the CCD
cameras in the camera beam in the outer slot of the
right, vertical profile (rear view).
3. Fasten the short cover
(2)
in the slot in such a way
that the installed USB connecting cables are cov‐
ered.
4. Place the USB connecting cables in the rear slot of
the right, vertical profile up to the cable clamp
(4)
.
5. Fasten the long cover
(1)
in the slot in such a way
that the installed USB connecting cables are cov‐
ered.
6. Attach the USB connecting cables
(3)
to the cable
clamp
(4)
by means of cable ties.
— Make sure that the USB connecting cables have
enough slack to allow connection to the laptop/
tablet.
DAS 3000 S20 | 25 | en
