1 689 989 485 | 2020-08-01
Robert Bosch GmbH
4512009-13_shd
1
2
3
44
55
5
2
1
3
(1) Camera beam
(2) Edge of trolley
(3) Contact plate (CTA 104-x)
(4) Mounting bracket
(5) Recesses
---
5.7
Attaching the wheel holder (CTA 100-
x) with the reference board (CTA 400-
x) in the parked position
CAUTION
Risk of striking one's head on the mount for
the laptop/tablet. Minor injury.
One parked position is located below the
mount for the laptop/tablet. Pay attention to
the mounting for the laptop/tablet when remov‐
ing or attaching wheel holder CTA 100-x.
---
Engage wheel holder CTA 100-x
(1)
by placing the
prongs
(2)
into the holes intended for this purpose
(3)
.
Wheel holder CTA 100-x is now resting against the
rubber buffer
(4)
.
1
2
33
4
4712009-05_shd
2
(1) Wheel holder CTA 100-x
(2) Prongs
(3) Holes
(4) Rubber buffer
---
5.8
Attaching calibration board 1 681 098
011 (CTA 300-1) in the parked posi‐
tion
1. Set down calibration board CTA 300-1
(3)
between
the frame and trolley on the edge protection
(1)
.
2. Make sure calibration board CTA 300-1 does not trap
the USB cable at the bottom of the frame.
3. Use safety adapter R
(2)
to secure calibration board
CTA 300-1
(3)
at the top edge.
If calibration board CTA 300-1 is not secured in
the parked position by safety adapter R
(2)
, it
may be damaged when the DAS 3000 S20 is posi‐
tioned or moved.
2
1
4712005-38_shd
33
(1) Edge protection
(2) Safety adapter R
(3) Calibration board CTA 300-1
---Separator---
5.9
Fastening the indicator bar in the
parked position
1. Push both slides
(4)
on the indicator bar up.
2. Position the indicator bar
(1)
in the mount
(2)
near
the bottom of the trolley.
3. Clamp one slide
(4)
in the retaining bolts
(3)
near
the top of the trolley.
The indicator bar is now in the parked position.
The clamped slide
(4)
secures the indicator bar in
the retaining bolts
(3)
.
1
2
4
4
33
4712005-37_shd
(1) Indicator bar
(2) Mount
DAS 3000 S20 | 31 | en
