Page 13
3BE390954NU – 07/15
BONNET GRANDE CUISINE
Registered office:
Rue des Frères Lumière - Z.I Mitry Compans
F-77292 MITRY MORY Cedex
Number of buzzer bips: « BuZZ »
Adjustable from 1 to 10
« InF »: Continuous
Default setting is « 3 »
Adjust the year: « YY » (in English)
Example : 2015
The temperature shows the Parameter
and the timer zone the Value.
Adjust the month: « MM »
Example : 12
The temperature shows the Parameter
and the timer zone the Value
Adjust the day: « dd » (in English)
Example : 18
The temperature shows the Parameter
and the timer zone the Value
Adjust the hour: « HH » then « Mn »
Example : 10:30
The temperature shows the Parameter
and the timer zone the Value
Preheating: « PrEH » (in English)
« YES »: Preheating at start up
« no »: No preheating
Default setting is « YES»
Unit of temperature: « C-F »
« °C »: Degrees Celsius
« °F »: Degrees Fahrenheit
Default setting is « C »
Preheat temperature: « PrEH°
c
»
Select a temperature
Default setting is « 175»
Core temperature by default: « SC°
c
»
Temperature in holding mode:
« HoLd°
c
»
Select a temperature
Default setting is « 75°»
Length of temperature holding cycle:
« HLd »
Select a time
Default setting is « -- -- »
Screen saver: « StbY »
Adjusts: from 5 / 10 / 30/ 60 / 90
« no »: Stays on
Default setting is « 5 »
Cooling cycle with/without water: « H2o »
« YES »: With water
« no »: Without water
Default setting is « YES »
2.5.6 « HACC » MENU: HACCP DATA
Pressing on the “HACC” zone gives access (as would
pressing the “PROG/VALID” button or the coder)
Access to this menu is by PIN code (restricted access)
Pressing the Parameter allows it to be adjusted (as would
pressing the “PROG/VALID” button or the coder)
Values are shown in the temperature zone
Moving from one value to another can be done using the
coder or with the
/
buttons
Possible settings:
- “no”: no recording
- “1”: Every minute
- “2”: Every 2 minutes
- “5”: Every 5 minutes
Default setting is
“no”
Once adjusted pressing the code or the “PROG/VALID”
button validates the selection
