BOMANN GSPE 885, Instruction Manual, Page: 9 / 24

9
Water connection Water connection Water connection Water connection
CAUTION: CAUTION: CAUTION: CAUTION:
•
The Installation of the water supply must conform to the local laws and regulations.
•
The appliance is not not not not suitable for hot water supply.
•
Use the new supplied hose set to connect the appliance to the water supply. Do not reuse old or used
connection sets.
•
If the water pipe is new or long time not used, ensure before connecting to the water system, that the water
is clear and free from contamination.
Not
Not Not
Notes on inlet hose safety system
es on inlet hose safety system es on inlet hose safety system
es on inlet hose safety system (not included)
(not included) (not included)
(not included)
The safety system consists of a double-walled inlet hose. This system guarantees to cut off the water supply
when leakage of the inner hose. Switching off the water supply leads over an electronic contact.
If necessary, you can order an inlet hose safety system from your dealer or in our online accessories shop,
www.bomann.de
www.bomann.de www.bomann.de
www.bomann.de . To order, use the reference number found under “Technical Data”.
Connect the water
Connect the water Connect the water
Connect the water inlet
inlet inlet
inlet hose (cold water connection)
hose (cold water connection) hose (cold water connection)
hose (cold water connection)
NOTE NOTE NOTE NOTE::::
The water pressure must be between 0.04 and 1 MPa. With higher pressure: use a pressure regulator.
•
Connect the water inlet hose to a water thread with ¾“. Screw the hose firmly in the direction
of the screw thread; pay attention for a tight fit.
•
Connect the other end of the inlet hose to the inlet valve on the appliance back; pay attention
for a tight fit too.
Connect the water drain hose
Connect the water drain hose Connect the water drain hose
Connect the water drain hose
NOTE
NOTE NOTE
NOTE::::
The drain hose has a length of approx. 1.5 m and can extend with a suitable hose and connecting piece to a
length of max. 4 m.
CAUTION CAUTION CAUTION CAUTION::::
In order to prevent backflow of contaminated water, the free end of the hose must not come under the water
level of the drain.
•
Connect the drain hose to a drain pipe with a minimum diameter of 40 mm; alternatively the drain hose
can be fixed to a sink or directly to the drainage.
•
Always make sure that the hose is not bent or squeezed. Use the sup-
plied drain hose suspension (a).
•
The hose must be installed at a height of min. 400 mm and max.
1000 mm above the rinsing floor.
•
Attach the drain hose securely in order to avoid a change in position and
with it a water leakage.