Bomag BW 213 D-4, Operating Instructions, Maintenance Instructions

Page: 63 / 102

Every 250 operating hours
BOMAG
63
BW 213 D-4
5.15 Checking the oil level in left/
right wheel hubs
Fig. 79
l
Move the machine until the oil level inspection
plug 1 (Fig. 79) is in horizontal position.
l
Clean and unscrew the plug.
The oil level must reach the bottom edge of the
bore.
l
Top up oil, if necessary.
For quality of oil refer to the table of fuels and
lubricants.
l
Screw the plug back in tightly.
l
Repeat this inspection on the other side.
5.16 Check the oil level in the vi-
bration bearings
i Note
Check only at operating temperature after running
the machine approx. 1/2 hour with vibration.
l
Park the machine on level ground.
Fig. 80
l
Move the drum, until oil level inspection plug 1
(Fig. 80) on the left hand side of the drum is in
bottom position.
l
Unscrew level inspection plug (1).
Some oil should run out of the inspection bore.
l
If necessary unscrew oil filler plug (2) and fill in
some oil through the oil filler bore (2), until oil
starts to drip out through the inspection bore.
For quality of oil refer to the table of fuels and
lubricants.
l
Screw oil filler (2) and level inspection plug (1)
back in tightly.
l
Repeat this inspection on the other side.
! Caution
If a loss of oil is found perform trouble shoot-
ing, repair the drum if necessary.