Bolin Technology D Series, User Manual

Page: 11 / 47

11
Camera Installation
This device is designed for indoor use only.
It is not designed to be used outdoors. Do not operate the device where it may meet constant heavy water. Please avoid
installing the unit in a location commonly exposed to sunlight for extended periods of time. Do not install the unit near
temperature adjustment device, such as a heating or cooling unit.
Failure to comply may cause abnormal behavior during operation or physical damage to the device.
Do not install the device in the following type of locations:
•
In locations where the temperature is below -10 Celsius (32F) or above 40 Celsius (104F)
•
On walls without proper mounting method and brackets
•
In locations where humidity is 81% or higher
•
In locations where it may be exposed to harmful chemicals
•
Near sea where device can be exposed to corrosion
•
In locations where the device will be exposed to strong radiation
•
In locations where the device will be exposed to strong radio waves
•
In locations where the device will be exposed to strong magnetic fields
•
For other potentially questionable locations email Bolin Support for any questions or concerns
Safety Matters
For your safety, please disconnect all power to the device when installing and removing the device. Always use supplied
accessories and do not modify the s.upplied power adaptor.
Only qualified personnel should install and remove this device. Please make sure the installation environment is safe and
follows best practices prior, during, and after the installation process. Bolin does not accept any responsibility or liability
for any accident or damages resulting from malpractice or improper installations.
The following chapters will introduce the installation methods of the Dante AV camera.
Before mounting your camera, please make sure you have purchased the optional accessories needed
for the installation.
•
Disconnect the power from the camera before camera installation.
•
Accessories such as the Wall mount and Ceiling mount are necessary for the installation.
•
Verify the bearing capacity of the mounted position.
•
Tighten all the screws to hold the camera securely.