Bolin Technology D Series, User Manual

Page: 6 / 47

6
•
Do not touch sensor modules with fingers. If cleaning is necessary, use a clean cloth with a bit of ethanol
and wipe it gently. If the camera will not be used for an extended period of time, put on the lens cap to
protect the sensor from dirt.
•
Do not aim the camera lens at the strong light such as sun or incandescent lamp. The strong light can
cause fatal damage to the camera.
Maintenance Precautions:
•
If there is dust on the front glass surface, remove the dust gently using an oil-free brush or a rubber
dust blowing ball.
•
If there is grease or a dust stain on the front glass surface, clean the glass surface gently from the
center outward using anti-static gloves or an oil-free cloth. If the grease or the stain still cannot be
removed, use anti-static gloves or an oil-free cloth dipped with detergent and clean the glass surface
gently until it is removed.
•
Do not use organic solvents, such as benzene or ethanol when cleaning the front glass surface.
Regulatory Compliance
FCC Part 15
This equipment has been tested and found to comply with the limits for digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the interference at his own
expense.
This product complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired operation.
LVD/EMC Directive
This product complies with the European Low Voltage Directive 2006/95/EC and EMC Directive
2004/108/EC.
WEEE Directive
–2002/96/EC
The product this manual refers to is covered by the Waste Electrical & Electronic Equipment
(WEEE) Directive and must be disposed of in a responsible manner.
Disclaimer
The contents of this document are subject to change without prior notice. Any updates and content changes will be added
to the subsequent new manual version.
If there are any concerns, please contact Bolin Support Team at www.bolintechnology.com
Website Reference and other information
For related product information please visit Bolin Technology website https://bolintechnology.com/