bolid Signal-10, User Manual

Page: 7 / 98

Signal-10 General
7
www.bolid.com
Automatic control for various engineering equipment used within security systems (such as
heaters, coolers, ventilators, air conditioners and so on) in accordance with a selected pro-
gram
While being operated by a network controller, centralized control for device executive outputs
and involving them into complicated automated control logic
While being operated by a network controller, transmission to the Orion system all information
about controlled events, namely addressable detector’s and alarm loop’s condition changing,
loop arming and disarming attempts, various troubles of alarm loops, relay outputs and the de-
vice itself, and so on. This information can be given to an operator or security system adminis-
trator, or written into a log for following analysis, or transmitted to a centralized indicator de-
vice, etc.
Remote measuring current resistance values of alarm loop along with included devices in ADC
units
Arming/disarming of alarm loops is implemented by using electronic keys which can be Dallas iBut-
tons (Touch Memory devices) or other identifiers with 1-Wire (µ-LAN) output interface. To read elec-
tronic keys an external reader is to be connected to the relevant input of the Signal-10. The device
provides indication of current partition conditions and results of requested operations by means of
two-color reader LED.
The keys have to be pre-programmed, that is enrolled either into the device memory (if alarm loops of
the device are armed/disarmed locally) or into the network database (under centralized control) along
with the rights to arm/disarms the particular loops of the device assigned to each key.
The device can be powered by one or two (the main and the extra) power supplies providing 12 or 24
Volt of DC. It is strongly recommended to use Bolid manufactured battery backed power suppliers of
series RIP-12 or RIP-24.
To program the Signal-10 device for adapting to particular user conditions and meeting specific user
needs the Orion device configuration tool, UProg.exe program, has to be used. The latest version of
the UProg Configuration Tool can be downloaded from the Bolid website at the address of
www.bolid.com . To program the device by means of the UProg, it should be connected to a PC with
UProg.exe installed via one of Bolid manufactured interface converters such as PI-GR, S2000-PI,
S2000-USB, or USB-RS485.
The Signal-10 is equipped with a tamper switch which provides generating tamper alarms while tam-
per conditions are changed and transmitting them to a network controller.
The Signal-10 Intrusion and Fire Alarm Panel is intended for indoor installation and round the clock
operation. The device is not suitable for operation in corrosive and dusty environments, as well as in
fire-hazardous or explosive areas.