BodyCraft HFT PRO, Owner'S Manual

Page: 29 / 45

Product Assembly STEP
28
16
NOTE: DO NOT tighten bolts until Step # 17
a. Pull Cable (27) down to the Pulley P8 (36) mounted at the Base Frame Leg (1). Enter Cable
on weight stack side and pull upward towards bracket at the Right Pulley Height
Adjuster (15R). Secure Pulley P8(36) with Bolt (51), Washers (62) and Nut (69).
b.
Pull end of Cable (27) bolt end and screw on the
bracket at the Right Pulley Height Adjuster (15R).
Make sure to screw min. 1/2” of thread into the bracket.
c. Adjust Bolt on Cable (27) end to take out slack
in cable. Then hand tighten jam nut.
d. Perform the same procedure from a, b, and c
to opposite side.
Hardware used for Step #16
Item # Description Qty Pic
53 3/8" X 2" BLACK HEX BOLT 2
62 3/8" BLACK WASHER 4
69
3/8" BLACK NYLON NUT
2