Form
No.
1540-69
r9/29/17 ©
2017
Bobrick
Washroom
Equipment,
Inc. Printed
in
U.S.A.
Page 7
68-7/8''
(175cm)
41''
(104cm)
64''
(163cm)
Panel
Centerlines
Floor Anchors
13-1/4''
(34cm)
18''
(46cm)
Wall Post
54-1/2''
(138cm)
27-1/2''
(69cm)
64''
(163cm)
18''
(46cm)
Panel Centerline
64''
(163cm)
18''
(46cm)
Floor Anchors
Panel Centerline
64''
(163cm)
18''
(46cm)
Panel/Stile
Centerline
64''
(163cm)
Floor Anchors
18''
(46cm)
Panel/Stile
Centerline
CHROME HARDW
ARE
A. Measure and mark the locations of centerlines for all the stiles and panels on walls.
B. Using the wall brackets as templates, measure and mark the location of all mounting holes plumb, according to
dimensions shown in illustrations (Fig. 3a, 3b, 3c).
C. Use #19 (.166) drill bit (4.2mm) x 2" (50mm) pilot hole into adequate wall backing.
D. Secure wall brackets with #12 x 2" (M5.5 x 50mm) screws.
INSTALL WALL BRACKETS AND WALL POSTS
STEP 3
Fig. 3a: Front-Entry Corner Layout with Wall
Post
Fig. 3b: Floor-Anchored or Ceiling-Hung
Alcove Open Layout. Inswing Door.
Fig. 3c: Overhead-Braced
Alcove Closed Layout.
These mounting points require wall backing.
Obtain Dimension from Bobrick Layout Sheet.
WALL POST #1002254
A. Determine the location and hand of the 1" X 1-1/2"
(25 x 40mm) stainless steel wall post being installed.
Outside edge of wall post to be in-line with outside
edge of keeping stile. The wall must have adequate
backing at mounting location to support door hung in
place.
B. Install wall post at given height and fasten, plumb in
both directions to wall with (5) wall screws provided.
Install (2) post end caps and (5) mounting hole plugs.
C. Attach door with through bolts provided as you install
door(s) on page 13 and 14.
