Large end of pan connector
can be trimmed to suit setout.
Threaded
section can be
trimmed to
required size.
Please note
−
Installation shall be in accordance with AS/NZS3500.
−
All measurements are in millimetres. Height dimensions
are to base of pan. Make allowance for bedding.
−
Bedding: Pan may be bedded with cement base or using
silicone sealant. Fix pan to floor using a sand cement
mixture of 3:1 to a depth of 60mm. Do not use lime or
fast-drying cement.
seima.com.au
−
Bracket fixing: The pan should be bedded with silicone
sealant and fixed with the brackets supplied.
−
Do NOT use epoxy type adhesives.
−
Dimensions are nominal and subject to normal ceramic
manufacturing variations.
−
Specifications may vary without notice as part of our
continuous improvement practices.
−
Clean with a damp cloth. Do not use abrasive cleaners,
liquids or pastes.
CISTERN PACKAGE CONTENTS
1 x ceramic cistern lid
1 x ceramic cistern base
Cistern is supplied with flush
valve and dual purpose inlet
valve already installed.
PAN PACKAGE CONTENTS
1 x ceramic pan
1 x pan connector
For connecting pan to
floor outlet pipe/S-trap.
1 x threaded section
(with flange plate)
Flange attaches to wall;
threaded section links to
pan connector.
2 x concealed
fixing brackets
Optional — can be
used to connect
pan to floor.
2 x floor bolts
(+ white plugs)
2 x washers
Optional fixing #2 —
used with fixing brackets
to secure pan to floor.
Bolt is inserted through
bracket base hole.
2 x caps (chrome plated)
2 x screws
2 x pan plugs (white)
Optional fixing #2 — used to
secure pan to concealed fixing
bracket. Plastic plug is placed
into hole in side of pan exterior,
screw is rebated into plug
and then screws into a hole
in upright section of bracket.
Chrome cap is used to cover
plastic plug.
IMPORTANT
1 Inspect the components before installation to ensure there are no visible
defects. If a defect is found, do not install the toilet suite and contact the
supplier immediately. Claims for defects will not be accepted after the product
has been installed.
2 This toilet suite is suitable for a variety of set-ups:
Cistern — accommodates either Back Entry Inlet connection or Bottom Entry
Inlet connection (left or right stop valve).
Pan — universal trap — accommodates S-trap installation or P-trap installation
(using appropriate connector; not supplied).
3 The toilet suite must be installed by a licensed plumber. Failure to do so may
void the warranty.
4 Installation must be in accordance with AS/NZS3500.
2 x bolts w seals
For attaching
cistern to pan.
2 x plugs
Plugs can be used to
plug holes in sides of
pan if required.
1 x rubber seal
For sealing outlet at
base of cistern.
1 x flush button
Half flush left, full
flush right.
Note: The cistern can
be adapted for bottom
entry plumbing. The
bottom entry inlet
valve shown above is
an optional extra.
OPTIONAL EXTRA
bottom entry
inlet valve
Installation Guide
Limni Wall Faced Toilet Suite
limni-wf-in | v 3.0 | page 1 of 4
